Ventilation

In old houses the draughts provide the ventilation – so when you seal the leaks you need to think about ventilation. The simplest form of ventilation is of course opening the window after a shower. It may seem odd to go to all that effort sealing gaps to then open the window, but the important thing is that a short while later you can close the window – ventilation is controlled air flow.

I discovered that what I had assumed was an extractor fan in the cooker hood was actually just circulating – merely filtering out grease and blasting out the air slightly higher up, straight back into the kitchen. It wasn’t dealing with the steam from the hob at all. So where the cooker hood met the ceiling I cut a hole and ran ducting through the roof space to a vent in the roof tiles. Now steam from cooking is extracted to the outside instead of condensing on the windows and walls.

In a new, air tight house you might provide whole house Mechanical Ventilation with Heat Recovery. This often sits in the loft and has ducting to every room, extracting stale, humid air from bathroom and kitchens, and supplying fresh air to living spaces and bedrooms. The outgoing air passes through a heat exchanger to warm the incoming air, so you get fresh air whilst keeping most of the heat.

However, it may be tricky to retrofit to a standard where it’s worthwhile spending a grand on that kind of kit. So I compromised with this…

Extractor Fan with Heat Recovery

We installed a single room extractor fan with heat recovery in the bathroom. It’s designed to run permanently on trickle, or kicks up to boost when humidity is high.

So during the day, with the bathroom door open, it gently removes stale air from upstairs. This, for example, deals with the moisture from clothes drying on the ceiling rack just outside the bathroom.

When you take a shower the humidity sensor automatically switches to boost until the air is dry again.

 

Single Room Extractor Fan with Heat Recovery

Product Vent Axia Lo-Carbon Tempra
Cost £265
Consumption 2W on trickle
Supplier Extractor Fan World

 

Extractor Fan with Heat Recovery
Extractor Fan with Heat Recovery
Open the cover, and inside we can see the heat exchanger. Incoming air cyclones around the small tubes, and is heated by the outgoing air within them.
Open the cover, and inside we can see the heat exchanger. Incoming air cyclones around the small tubes, and is heated by the outgoing air within them.

Pros: Very effective ventilation. We never open the window in winter. Virtually zero mould growth now.

Cons: Audible. Not ‘almost silent’ as claimed when running on trickle. Sounds like a hair drier on boost.

Heat recovery effectiveness? Difficult to measure.